The Operating System for Trucking 24/7  +1 (469) 253-7575or we call you →
Step Deck Report · Week 29, 2026

Step Deck Rates — Week 29, 2026

The national step deck benchmark for the week of 13 July 2026 to 19 July 2026, snapshot recorded 13 July 2026: what the carrier is paid, what the shipper pays, what it works out to on a real lane, and what it leaves the truck once its own costs are covered.

The week 29 step deck number

MeasureWeek 29, 2026What it means
Carrier rate per mile$3.74What lands on the rate confirmation.
Shipper all-in per mile$4.30Before any accessorial actually incurred on the load.
vs prior snapshotn/c *Not comparable — see below.
Snapshot recorded13 July 2026Never edited afterwards — this page keeps showing the week 29 number.

No week-over-week change is shown. The previous snapshot was recorded on a different basis, and a percentage across that break would describe a change in how we build the number rather than a change in the step deck market.

National benchmark, not a proprietary index. This figure is not built from our own booked loads and we do not present it as though it were. Use it to sanity-check a quote, not to replace the lane in front of you. The evergreen Step Deck rate hub carries the full specification table, the regional breakdown and the seasonal pattern behind it.

The specification behind this equipment’s number

The $3.74 benchmark assumes freight that is legal and normal on this equipment. These are the numbers that decide whether yours is:

Trailer length48 ft and 53 ft; typically 37–43 ft of lower deck
Deck heightsUpper deck ~60″, lower deck ~40″ from the ground
Legal load heightAbout 10′ on the lower deck versus 8⁄6 on a flatbed
Max payload45,000–48,000 lb
RampsSome carry them, many do not — always state whether you need them

Commonly shipped on step deck: Construction equipment, agricultural machinery, tall industrial parts, bundled steel, crated units, HVAC and generator sets, tanks.

Put the real figures on the posting. Every hour spent confirming a load is legal on the trailer is an hour nobody is paying for, and it is the most common reason a rate that looked fine ends up renegotiated at the dock.

Week 29 on a real step deck lane

This week’s benchmark multiplied by real lane distance. A starting point for a conversation rather than a quote — direction, season and the receiving requirement all move the true number, and none of them are in a national average.

LaneDistanceCarrier getsShipper pays
Peoria, IL → Houston, TX1,050 mi$3,927$4,515
Charlotte, NC → Kansas City, MO900 mi$3,366$3,870
Portland, OR → Salt Lake City, UT770 mi$2,880$3,311

Distances are practical truck miles and will differ slightly from a car routing.

What week 29 leaves a step deck truck

Against a working all-in operating cost of $1.90 per mile for a one-truck carrier, this week’s step deck benchmark of $3.74 leaves +$1.84 per loaded mile — about $1,288 on a 700-mile run, before deadhead and before any unpaid time at a dock.

That gap is not profit. It is what has to absorb the empty miles to the next pickup, a wait nobody paid for, a week with a bad reload, and the repair that has not happened yet. A rate that clears the floor by a few cents only works if nothing goes wrong. Work out your own cost per mile →

What moves the step deck number at all

Week to week, mostly noise. Over a season, these are the things that actually decide where this benchmark sits.

HeightThe entire reason this trailer exists. Freight between roughly 8⁄6 and 10′ tall needs the lower deck to stay legal.
Trailer scarcityThere are far fewer step decks than flatbeds. On a thin lane you are competing for a small pool, and the rate reflects it.
RampsSelf-propelled equipment needs ramps, and not every step deck carries them. Say so in the posting or you will lose a day.

The full step deck rate hub → carries the rest, plus the specification table, the regional breakdown and the accessorial impact.

Keep reading

Post a step deck load →

Week 29 step deck questions

What was the step deck rate per mile in week 29 of 2026?

The national benchmark was $3.74 per mile to the carrier for the week of 13 July 2026 to 19 July 2026, which works out to about $4.30 all-in for the shipper before accessorials.

Is $3.74 a good step deck rate?

It depends entirely on your own cost per mile. Against a working all-in operating cost of $1.90 for a one-truck carrier it leaves +$1.84 per loaded mile — before deadhead, which typically takes a further sixth off it.

Why is my step deck quote different from this number?

A national benchmark blends lanes running in both directions, appointment and FCFS freight, and every region at once. Your lane is one direction, one receiving requirement and one market. Direction alone can move a real quote by a third.

Do these figures include detention and other accessorials?

No. Detention, layover, TONU and lumper fees all sit outside the per-mile number. On a short lane they can be worth more than the whole margin — see the detention policy.

Will this page be updated with newer rates?

No, and deliberately so. This is a dated report and it keeps showing the week 29 number. The evergreen Step Deck rate hub always carries the current figure.

Keep exploring

Related services & guides

Get a QuoteGet Started